How to Clean and Lubricate Locks05/29/2015 Back To Blog
We never think of the obvious when security lock problems arise. We always think of the worst and so simple solutions don't even cross our minds. When the key is not inserted in the lock with ease, we prefer to replace the key or even the lock and forget that often simpler solutions would suffice. You cannot imagine what cleaning and lubrication can do! These tasks are not always the solution and some problems still require key and lock replacement. Though, by keeping the door and window locks clean and lubricated, one can be sure they will work better and last longer. As Locksmith Hampton explains when you put the key in the lock and cannot turn it easily or when you have a hard time inserting it in the first place, the lock is stiff. It is stiff because it is dirty.
We hardly realize that locks get dirty, too. Though, dust and debris are accumulated in the mechanism and mix with the existing lubricants. That's why the lock becomes stiff. In order for the key to be inserted in the lock and turn with ease, its serrated parts must match the pins of the cylinder. If they are covered with dirt, the key won't be able to move the right way and this is the reason why we have a hard time putting it all the way in the keyhole. So, here are some instructions of how to take care of such problems. Keep in mind that by cleaning and lubricate locks occasionally, you can avoid problems often related to house lockouts.
Find out how to take care of your locks
The easiest way to deal with a stiff lock is to spray a special lubricant into the keyhole and on the key and then try to insert with gentle moves. If that method doesn't work, you will have to disassemble the mechanism in order to clean and lubricate the parts before assembling it again. In order to remove the mechanism, you must first remove the knob of your security door. Remove the screws holding it in place and then slide the handle off the spindle. By keeping pressure on the spring so they won't pop out or get ruined, remove the mechanism. In addition, remove the faceplate from the edge of the door and place all components on tissue paper. You must clean the cylinder well using a toothbrush, which help remove debris. Use canned air to blow away dust and debris residue.
Before lubricating the parts, make sure they are clean from old lubricants. You might have to wipe them well with a soft cloth. Canned air might release some moisture, which if not dried well before reassembling the lock, might cause rust. Then you can lubricate the parts but do not saturate them. Parts just need enough lubricants so the key turns smoothly. When you are done, reassemble the lock. Place the latch bolt at the edge of the door and then put the exterior knob on the spindle and make sure the spindle passes through the latch bolt mechanism to the other side. Put back the interior knob and before tightening all screws make sure the bolt of your deadlocks come out alright and is aligned with the strike plate.